Toyota Tundra 5.7 Oil Capacity by Model Year

The generation break that matters for Tundra 5.7L 3UR-FE

The sources document a real capacity change within the long second-generation run: Toyota's 2010–2014 application chart shows 7.9 qt with filter, while the 2019 owner manual shows 8.5 qt with filter. Read the model-year and engine row together; a badge, displacement, or oil cap by itself may span more than one internal engine revision. The values below are drain-and-refill quantities with the filter unless the row says otherwise.

Do not choose a row by displacement alone, and do not mistake the 2019 without-filter figure for a normal oil-and-filter service. Confirm flex-fuel status and model year, install the cartridge-filter O-ring in its proper groove, refill below the reference amount and finish by dipstick. Use the oil grade and manufacturer approval from the same model-year manual as the capacity. Capacity, viscosity, and approval are three separate specifications.

Oil-capacity chart for Tundra 5.7L 3UR-FE

Use the chart as an application lookup. The sources document a real capacity change within the long second-generation run: Toyota's 2010–2014 application chart shows 7.9 qt with filter, while the 2019 owner manual shows 8.5 qt with filter. A capacity printed beside the wrong engine code is not “close enough”; even engines sharing the same displacement can have different pans, filters, coolers, or drain-back behavior. If the vehicle has been swapped, rebuilt, or fitted with an aftermarket pan, use the installed hardware manufacturer's capacity and calibration marks.

The most common current application begins near 7.9 US qt. Begin below that amount and finish by measurement. The difference between the add and full marks is often about one quart, but do not assume that relationship when the dipstick is aftermarket, damaged, or paired with a non-original tube. Investigate a reading that remains absent or implausibly high.

Do not choose a row by displacement alone, and do not mistake the 2019 without-filter figure for a normal oil-and-filter service. Confirm flex-fuel status and model year, install the cartridge-filter O-ring in its proper groove, refill below the reference amount and finish by dipstick.

Common causes of a capacity mismatch

A particularly risky lookup error is treating 7.9 qt as the with-filter amount for every year. In the cited 2019 manual, 7.9 qt is specifically the without-filter row; the with-filter reference is 8.5 qt. If the verified dipstick result and the expected quantity disagree materially, stop and identify the cause instead of choosing whichever number is more convenient.

• The lookup used the model name but not the model year or engine code.
• The quoted figure excluded the filter while the filter was replaced.
• The vehicle was not level or the oil had not drained back before checking.
• An oil cooler, remote filter, aftermarket pan, engine swap, or incorrect dipstick changed the system.
• The old filter gasket remained on the housing or a leak began after startup.
• The crankcase was filled to the advertised capacity without a final dipstick check.

Procedures used with this specification

These steps are the same for every vehicle in this family, so they are documented once rather than repeated on each page. The values above remain specific to this Toyota Tundra 5.7L 3UR-FE.