2018 Nissan Rogue 2.5 Oil Capacity
2018 Nissan Rogue 2.5 Oil Capacity: 4-7/8 US qt with filter, application boundaries, refill procedure, dipstick check and official manual lookup.
Nissan lists 4-7/8 US qt (4.6 L) with a new filter for the 2018 Rogue 2.5L QR25DE.
Nissan lists 4-7/8 US qt (4.6 L) with a new filter for the 2018 Rogue 2.5L QR25DE. That number is a refill starting point for the identified engine, not permission to pour the entire amount without checking. Oil can remain in galleries, coolers, a tilted pan, or an old filter, and aftermarket pans can change total volume. The safest method is to verify the engine code and model year, use the correct viscosity and approval, refill slightly below capacity, circulate the oil, wait, and finish by the dipstick.
This guide separates similarly named engines and model generations because capacity errors commonly come from a search result that omits the year or engine code. The table also distinguishes “with filter” from “without filter.” During a normal oil change, replace the filter and use the with-filter figure, then confirm the final level on level ground under the conditions specified by the owner manual.
Interactive Nissan 2018 Rogue 2.5L oil-service workflow
Branded downloads includedPNG and PDF exports carry the TorqueSheet logo, torquesheet.com, source-page URL, and republishing attribution request. The PDF source link is clickable.
Follow the workflow from vehicle identification through final dipstick verification. Published capacities are starting quantities, not a substitute for the level check.
2018 Nissan Rogue 2.5 Oil Capacity
| APPLICATION / ITEM | SPECIFICATION | NOTES |
|---|---|---|
| Oil and filter change | 4-7/8 US qt | 4.6 L; with filter |
| Final level | Verify after drain-back | Level ground and correct procedure |
The same table lists 4-1/2 qt (4.3 L) when the filter is not changed and recommends Nissan 0W-20 SN or equivalent. Because Nissan calls the capacities approximate, refill below the reference first, run the engine while checking the filter and drain plug, allow drain-back on level ground and finish by dipstick.
Oil-capacity chart for 2018 Rogue 2.5L
Use the chart as an application lookup. Applies to the full-size 2018 Rogue with the 2.5L QR25DE. It does not apply to the smaller Rogue Sport, which is a separate model with a different engine and manual. A capacity printed beside the wrong engine code is not “close enough”; even engines sharing the same displacement can have different pans, filters, coolers, or drain-back behavior. If the vehicle has been swapped, rebuilt, or fitted with an aftermarket pan, use the installed hardware manufacturer's capacity and calibration marks.
The most common current application begins near 4-7/8 US qt. Begin below that amount and finish by measurement. The difference between the add and full marks is often about one quart, but do not assume that relationship when the dipstick is aftermarket, damaged, or paired with a non-original tube. Investigate a reading that remains absent or implausibly high.
The same table lists 4-1/2 qt (4.3 L) when the filter is not changed and recommends Nissan 0W-20 SN or equivalent. Because Nissan calls the capacities approximate, refill below the reference first, run the engine while checking the filter and drain plug, allow drain-back on level ground and finish by dipstick.
Common causes of a capacity mismatch
The same table lists 4-1/2 qt (4.3 L) when the filter is not changed and recommends Nissan 0W-20 SN or equivalent. Because Nissan calls the capacities approximate, refill below the reference first, run the engine while checking the filter and drain plug, allow drain-back on level ground and finish by dipstick. If the verified dipstick result and the expected quantity disagree materially, stop and identify the cause instead of choosing whichever number is more convenient.
- The lookup used the model name but not the model year or engine code.
- The quoted figure excluded the filter while the filter was replaced.
- The vehicle was not level or the oil had not drained back before checking.
- An oil cooler, remote filter, aftermarket pan, engine swap, or incorrect dipstick changed the system.
- The old filter gasket remained on the housing or a leak began after startup.
- The crankcase was filled to the advertised capacity without a final dipstick check.
Nissan 2018 Rogue 2.5L specifications can change by model year, engine, platform, wheel, and installed component. Confirm the VIN or engine identity, part numbers, fastener condition, and the current manufacturer instructions before service.
Procedures used with this specification
These steps are the same for every vehicle in this family, so they are documented once rather than repeated on each page. The values above remain specific to this Nissan 2018 Rogue 2.5L.
2018 Nissan Rogue 2.5 Oil Capacity FAQs
How much oil does the 2018 Rogue 2.5L take?+
Nissan lists 4-7/8 US qt (4.6 L) with a new filter for the 2018 Rogue 2.5L QR25DE. Confirm the year/engine row and finish by the dipstick rather than treating the capacity as an exact pour-in amount.
Technical sources
TorqueSheet favors engine- and component-specific manufacturer instructions over unsourced universal values.
12018 Nissan Rogue Owner's Manual — capacitiesPrimary Nissan manual listing 4-7/8 qt (4.6 L) with filter and 4-1/2 qt (4.3 L) without filter for the QR25DE.↗